Home
Back
Op-Amp Non-Inverting Gain Equation:
| From: | To: |
The op-amp non-inverting amplifier configuration provides a voltage gain greater than unity with the input signal applied to the non-inverting terminal. This configuration offers high input impedance and is widely used in signal conditioning applications.
The calculator uses the op-amp non-inverting gain equation:
Where:
Explanation: The gain is determined by the ratio of feedback resistance to input resistance plus one. This configuration always provides gain greater than or equal to 1.
Details: Accurate gain calculation is crucial for designing amplifier circuits, signal processing systems, and ensuring proper signal amplification without distortion in electronic applications.
Tips: Enter feedback resistance (R_f) and input resistance (R_in) in ohms (Ω). Both values must be positive and non-zero for accurate calculation.
Q1: What is the minimum gain possible with this configuration?
A: The minimum gain is 1 (when R_f = 0 or R_in = ∞), meaning the output equals the input (unity gain buffer).
Q2: What are typical resistance values used?
A: Typical values range from 1kΩ to 1MΩ, depending on the application and desired gain. Higher resistances reduce power consumption but may increase noise.
Q3: What are the limitations of this configuration?
A: The gain is limited by the op-amp's bandwidth and slew rate. At high frequencies, the actual gain may be less than calculated due to these limitations.
Q4: How does this compare to inverting configuration?
A: Non-inverting configuration provides higher input impedance and positive gain, while inverting configuration provides lower input impedance and can have gain less than 1.
Q5: What is the input impedance of this configuration?
A: The input impedance is very high (typically >1MΩ) since the input is connected directly to the op-amp's non-inverting input.